镉胁迫下大豆中镉的分布状况及其籽粒品质

溶液培养中0.5μmol·L-1镉胁迫浓度下,大豆表现出轻微受害症状,籽粒减产25 . 7%,而籽粒中粗脂肪和粗蛋白含量变化不大.镉在大豆中的积累分布状况为根>叶>籽>油,比例为32.100:1.690:1.000:0.003.大豆籽粒含镉4.89mg/kg,超过了国家环境标准规定的最高容许量.而大豆粗脂肪中含镉仅0.015mg/kg,远低于国家食品环境卫生标准.豆粕中含镉6.17mg/kg,表明大豆籽粒中的镉主要存在于粗蛋白和淀粉中.     

Production of soybean ethanol-based biodiesel using CaO heterogeneous catalysts promoted by Zn,K and Mg

This article focuses on the optimization of the production of fatty acid ethyl esters from soybean oil using CaO-based heterogeneous catalysts. Three different catalytic promoters were evaluated: Magnesium, zinc, and potassium. The reaction has evaluated the promoter content (promoter to calcium molar ratio), catalyst load, alcohol to oil molar ratio, and temperature. Response surface methodology (RSM) was used to evaluate the influence of each variable on the yield of biodiesel. The addition of K₂O or MgO in the catalyst has enhanced the yield in fatty acid ethyl esters, while the use of ZnO as a promoter was not successful.     

含砷毒剂降解产物三苯胂对大豆萌发及幼苗生长的影响

采用不同浓度三苯胂(Triphenylarsine,TPA)沙质室内培养东北代表性作物大豆,研究日本遗弃在华化学武器("日遗化武")装填毒剂的主要降解产物之——TPA(C18H15As)对大豆萌发和幼苗生长的影响。结果表明:在0 mg/kg～400 mg/kg TPA浓度范围内,大豆受到的毒性效应随浓度增大而增大,直至无法生长;试验大豆的萌发率、根长、下胚轴长和株高等形态指标均随着培养介质中TPA浓度的增加而出现抑制效应明显增加的趋势;其中根系是大豆幼苗期砷累积的主要器官,也是对环境TPA毒害效应最敏感、响应最早的部位之一。日遗华武泄漏造成的土壤污染若处理不当会对埋藏地种植的大豆作物生长产生影响。     

Ce(Ⅲ)对UV-B辐射胁迫下大豆幼苗光化学反应的影响

用水培法研究Ce(Ⅲ)对UV-B辐射胁迫下大豆幼苗光化学反应的影响.结果表明, 20 mg·L^-1 CeCl₃使大豆幼苗净光合速率(Pn)、Hill反应、Mg²⁺-ATPase活性与光合磷酸化活力4项指标较对照提高23.2%～14.3%; 有效抑制UV-B辐射(T₁=0.15 W·m^-2和T₂=0.45 W·m^-2)胁迫下4项指标下降, 4项指标降幅［Ce(Ⅲ)+T₁为36.6%～15.9%,Ce(Ⅲ)+T₂为65.6%～33.2%］小于对应的UV-B辐射组(T₁为50.9%～23.3%,T₂为77.3%～51.4%). 动态变化显示, Ce(Ⅲ)减缓了胁迫期4项指标的下降趋势,促进了恢复期4项指标上升幅度. 说明Ce(Ⅲ)通过减轻UV-B辐射对大豆幼苗光化学反应的伤害, 遏制UV-B辐射胁迫下大豆幼苗Pn下降.     

酸雨与镧对大豆幼苗生长的复合伤害效应研究

为探索酸雨与稀土镧对大豆幼苗生长的复合影响及其内在机制,以重要油粮作物大豆(Glycine max)为材料,研究在模拟酸雨pH分别为3.0、3.5、4.5与稀土镧La(Ⅲ)浓度分别为60、100和300mg·L-1处理下大豆幼苗生长及光合作用的变化.结果表明,相对单一酸雨与镧处理,酸雨与La(Ⅲ)复合处理组中大豆幼苗的生长受抑制程度增大,两者呈协同效应,且pH越低,La(Ⅲ)浓度越高,抑制效应越明显.光合参数的变化规律与生长指标近同,相同处理组各光合参数的降幅不一致,其中最大荧光(Fv/Fm)和叶绿素含量(Chl)的降幅范围分别为9.53%～22.75%和9.14%～24.53%,较净光合速率Pn(22.78%～84.7%)、希尔(Hill)反应速率(15.52%～73.38%)和Mg2+-ATPase活性(14.51%～71.54%)小,表明各光合参数对2个胁迫因子的敏感程度存在差异.进一步相关性分析发现,Pn变化主要受Hill反应速率与Mg2+-ATPase活性的影响,而Chl、Fv/Fm次之.表明酸雨与La(Ⅲ)对植物光合过程各环节的作用机制不同,光合作用受阻是影响植物生长的重要因素之一.     

UV-B辐射增强与秸秆施用对大豆田土壤呼吸的影响

利用LI-8100开路式土壤碳通量测量系统测定土壤呼吸,研究了UV-B辐射增强和秸秆施用对大豆田土壤呼吸的影响.结果表明,UV-B辐射增强20%使土壤呼吸速率降低了30.31%,秸秆施用使土壤呼吸速率提高了14.51%,UV-B辐射增强+秸秆施用复合处理对土壤呼吸速率没有显著影响.UV-B增强提高了施用秸秆的碳转化率.对照、UV-B增强、秸秆施用和UV-B增强+秸秆施用4种处理的土壤呼吸与土壤温度都存在极其显著的指数关系(p0.01),拟合方程的决定系数R2分别为0.434、0.563、0.451和0.513.土壤呼吸温度敏感系数Q10值分别为1.55、1.91、1.80和1.71.可见,UV-B辐射增强、秸秆施用和UV-B辐射增强+秸秆施用提高了大豆田土壤呼吸的Q10.     

Biodegradable plastic made from soybean products. II. Effects of cross-linking and cellulose incorporation on mechanical properties and water absorption

Soy isolate was treated with formaldehyde and glyoxal at 1.0, 2.5, and 5.0% (w/w isolate) and with adipic and acetic anhydrides. The materials were then compression-molded into plastic tensile bars and tested for tensile and yield strength, percentage elongation, Young's modulus, and water absorption. Treatment with 5% formaldehyde increased the tensile strength significantly, to 4.9 kg/mm², compared with the untreated sample (3.7 kg/mm²). The yield strength increased slightly, to 0.68 kg/mm². Elongation was significantly less after treatment with formaldehyde. Young's modulus increased after treatment and leveled off at 174 kg/mm². Water absorption decreased as the formaldehyde concentration increased. Treatment with either glyoxal or adipic/acetic anhydride had a detrimental effect on the mechanical properties of the plastic specimens. Water absorption was decreased by glyoxal treatment but was not affected by adipic/acetic anhydride treatment. Long-fiber (lf), short-fiber (sf), and microcrystalline (mc) cellulose were incorporated into soy isolate at various levels. Cellulose addition decreased the percentage elongation and increased the rigidity of the plastic. All three cellulose additions increased Young's modulus. The tensile strength increased with the addition of sf-cellulose to soy isolate; lf-cellulose decreased the tensile strength, whereas the incorporation of mc-cellulose did not have a significant effect. The yield strength increased slightly with the addition of sf-cellulose and was less affected by the addition of lf- or mc-cellulose. All three types of cellulose slightly decreased water absorption at ca. 15% content.Journal Paper No. J-15563 of the Iowa Agriculture and Home Economics Experiment Station, Ames; Project No. 2863.     

Synthesis of cellulose-fatty acid esters for use as biodegradable plastics

Long-chain fatty acid carbohydrate esters (FACE) were synthesized by the acid chloride-pyridine reaction to different degrees of substitution (DS). The hydrolyzed soybean oil was used as the source of unsaturated fatty acids. High molecular weight FACE polymers are insoluble in common solvents, such as benzene, toluene, THF, etc., and are highly water resistant. However, FACE polymers of hydrolyzed cellulose (MW 180 kD) are soluble/swellable in toluene and can be cast into tough, flexible films. FACE polymer properties of tensile strength and clasticity vary with degree of substitution and polymer size.Paper presented at the Bio/Environmentally Degradable Polymer Society—Third National Meeting, June 6–8, 1994, Boston, Massachusetts.     

DNA同源性分析最终确定新疆中华根瘤菌（Sinorhizobium xinjiangensis）为一独立种

针对S.xinjiangensis分类地位的争议，从新疆再次分离获得34株快生大豆根瘤菌，在16SrDNAPCR-RFLP分析和SDS全细胞蛋白电泳分群的基础上，进行了16SrDNA全序列相似性和DNA同源性分析.所测4个菌株和S.fredii模式菌株USDA205的16SrDNA全序列有很高的相似性.而DNA同源性分析说明新分离的菌株代表与原定的S.xinjiangensis为一个DNA同源群.其模式菌株CCBAU110与S.fredii的2株参比菌株USDA194、2048之间的DNA同源性分别为31.5%和28.7%.S.fredii的模式菌株USDA205与新分离的菌株代表及原定的S.xinjiangensis的模式菌株和2个参比菌株之间的DNA同源性为20.8%～39%，远低于70%.属于种水平上的差异.按照国际细菌分类委员会以DNA同源性≥70%且△Tm≤5℃作为定种的标准，S.xinjiangensis是Sinorhizobium属中不同于S.fredii的一个独立的种.表3参20